How Often to Clean Your Dishwasher Filter

Why Your Dishwasher Filter Needs Regular Cleaning

The filter in your dishwasher works as a barrier between dirty water and your dishes. It catches food particles, grease, and debris that would otherwise recirculate onto your clean plates and bowls. Over time, this filter becomes clogged with the very things it's designed to trap. When the filter gets too dirty, water cannot drain properly from the wash cycle, which means your dishwasher has to work harder and may not clean your dishes effectively.

Learn About Florida Driver's License Renewal Process →

According to manufacturers like Bosch and Whirlpool, a clogged filter is one of the top reasons dishwashers fail to clean properly. The filter typically sits at the bottom of your dishwasher tub, often in the lower spray arm area. There are usually two types of filters: the upper filter, which catches larger particles, and the lower filter, which catches finer debris. Both need attention to keep your dishwasher running at peak performance.

When your filter isn't cleaned regularly, several problems can develop. Water may back up inside the tub, leaving dishes wet and spotty. The spray arms may not rotate properly because water pressure is reduced. You might notice unpleasant odors coming from your dishwasher because trapped food particles begin to decompose. In some cases, buildup can damage the pump or drain system, leading to expensive repairs.

Most dishwasher manufacturers recommend that you inspect your filter at least once a month. The actual cleaning frequency depends on how often you use your dishwasher and what types of dishes you wash. Households that run their dishwasher daily or wash particularly dirty cookware may need to clean the filter more often than those who use it a few times per week.

Practical Takeaway: Check your filter monthly by opening your dishwasher after a cycle and looking at the bottom of the tub. If you see visible food debris or a sticky film, it's time to clean it.

How Often You Should Clean Your Filter Based on Usage

The frequency of filter cleaning varies based on three main factors: how many times per week you run the dishwasher, the types of dishes you wash, and the number of people in your household. A family of four that runs the dishwasher once daily will need more frequent filter maintenance than a single person who runs it twice weekly.

How to Book Your California DMV Appointment →

For light use (2-3 times per week), a monthly cleaning schedule is typically sufficient. This usually applies to smaller households or those who hand wash most of their cookware. Once you remove the filter and rinse it under warm running water while using a soft brush to loosen debris, it should be clean enough for another month of use. Light-use households may sometimes go 6-8 weeks between cleanings without experiencing drainage or cleaning problems.

For moderate use (4-5 times per week), cleaning every two weeks is a reasonable target. This covers most average households. A simple routine is to clean the filter every other Sunday or every other Friday, making it easy to remember. Many people find that setting a biweekly phone reminder helps them stay on top of maintenance. At this frequency, you're preventing buildup before it becomes problematic.

For heavy use (daily operation), you should clean the filter once per week. Households that run their dishwasher every day—such as those with multiple children, frequent entertainers, or those who prefer not to hand wash anything—should establish a weekly cleaning routine. This might mean cleaning the filter every Sunday evening or every Friday after dinner. Some households with extremely heavy use report cleaning the filter twice weekly during particularly busy times.

If you frequently wash pots, pans, and baking dishes with stuck-on food, increase your cleaning frequency regardless of how many loads you run. These items leave more debris in the filter than everyday plates and glasses. Similarly, if you don't rinse dishes before loading them, the filter will accumulate more food waste and will need cleaning more often.

Practical Takeaway: Create a simple calendar reminder for your filter cleaning. Choose a frequency based on your household size and dishwasher usage—monthly for light use, biweekly for moderate use, and weekly for daily operation.

Step-by-Step Instructions for Cleaning Your Dishwasher Filter

Cleaning your dishwasher filter is a straightforward task that takes about 5-10 minutes and requires no special tools. Always start by stopping your dishwasher mid-cycle or waiting until a cycle is completely finished. Never try to remove the filter while the dishwasher is running or immediately after a hot cycle—let it cool for a few minutes.

Get Your Free HP Instant Ink Cancellation Guide →

First, open your dishwasher and locate the filter at the bottom of the tub. Most filters are located in the back corner or center of the tub floor. You'll typically see a cylindrical or rectangular plastic component. Some filters twist out counterclockwise, while others pull straight up. Check your dishwasher's manual to determine which type you have, but most modern dishwashers use the twist-out design. Grasp the filter firmly and rotate it about a quarter turn to the left. It should come free easily—don't force it.

Once removed, hold the filter over your sink and use your fingers to remove any large food particles, hair, or debris. This initial clearing prevents your sink drain from getting clogged. For stuck-on food, use a soft dish brush or an old toothbrush. Do not use a wire brush or abrasive scrubber, as these can scratch or damage the filter material. Rinse the filter thoroughly under warm running water, brushing gently while the water flows over all surfaces.

For filters with stubborn buildup or sticky residue, soak them for 15-20 minutes in a mixture of warm water and white vinegar (equal parts). The vinegar helps dissolve grease and mineral deposits. After soaking, scrub gently with a soft brush and rinse thoroughly. Some people add a tablespoon of baking soda to the vinegar mixture for extra cleaning power. Never use hot water above 140°F on plastic filters, as extreme heat can warp them.

Before reinstalling, inspect the filter for damage such as tears, cracks, or missing sections of the mesh. A damaged filter won't catch debris properly and should be replaced. If the filter looks intact, insert it back into its slot and twist clockwise until it's snug. It should sit flush with the bottom of the tub—you shouldn't see any gaps around the edges. Replace the top filter or strainer basket if your model has one, and close the dishwasher door.

Practical Takeaway: Create a simple routine: twist out the filter, remove large debris, rinse under warm water with a soft brush, soak if needed, check for damage, and reinstall. The entire process should take less than 10 minutes.

Signs Your Filter Needs Immediate Cleaning

Certain warning signs indicate that your filter needs cleaning right away, even if your regular maintenance schedule isn't due yet. If you notice water pooling at the bottom of your dishwasher after a cycle completes, this usually means the filter is clogged and water can't drain properly. Stop using the dishwasher and clean the filter before running another cycle. Allowing water to sit in your dishwasher creates opportunities for mold and mildew growth.

Get Your Free Guide to Notary Services Options →

Unpleasant odors coming from your dishwasher are another clear signal. A clean dishwasher should smell fresh or neutral. If you notice sour, rotten, or musty smells, trapped food particles in the filter are decomposing. Clean the filter immediately and then run an empty cycle with a cup of white vinegar placed on the top rack to sanitize the interior. The smell usually disappears within a day or two of cleaning.

Poor cleaning performance is a common indicator of filter problems. If your dishes aren't coming out as clean as they normally do, food particles are likely present on the dishes because the filter is preventing proper water circulation. Check the filter before assuming you need to adjust your wash cycle settings. Often, a simple filter cleaning restores normal cleaning performance.

Visible debris or a slimy film on the filter surface means cleaning is overdue. During your monthly inspection, if you see food particles sticking to the filter or a slippery coating, it's time to clean. This buildup reduces water flow and strain on your dishwasher's pump. Discoloration of the filter—turning brown or gray—indicates mineral deposits